How-To Install A Fence

Step 1.    Stake string lines for each run

A. Determine corner and end post locations. Drive stakes into the ground a few feet beyond that point so the string lines can cross making a 90° angle.

B. Run a tight string line between stakes to mark the fence line. The stakes should be tall enough so the string does not touch the ground.

Step 2.    Set the end, corner, and gate posts

A. Dig holes at least 6" in diameter and 2' deep depending on size of posts. Scoop loose dirt out of the hole and measure to check depth. If too shallow, keep digging, if too deep add some loose gravel. Set post in hole and measure to assure proper depth.

B. Shovel your mixed concrete around post; fill to 4" below ground level. Pack the excavated dirt tight around post, this will help keep your post from moving. Make sure the post is plumb against the string line and check for levelness.

Step 3.    Install line posts and attach sections

A. Start at an end, corner, or gate post and dig three holes in the direction of your fence line. Holes should be dug 73" apart on center for 2" posts and 6' wide sections. This number will change if you are using a larger post and/or 8' wide fence sections.

B. Slide a fence section into the starting end, corner, or gate post, then slide a line post on the opposite side. Then concrete the line post in the ground following step 2b. Repeat this procedure down your fence run; installing section - line post - section - line post. Don't forget to secure each section with the self-tapping screw provided by the manufacturer.

Step 4.    Hang gates and attach gate latch

How to handle "special situations"

Cut Sections

With most installations there will be a wrought iron fence line that will not fit a full section and it will need to be cut. This is a simple task and can be accomplished with a hacksaw. Make sure you measure twice and cut once. A wrought iron fence section can always be trimmed down but cannot be extended to fit.

Odd Angle Corners

A swivel bracket is used when you need to make a turn in your  wrought iron fence line that is not 90° where a corner post is normally utilized. By using multiple swivel brackets you can also make a radiused turn.

Hillsides & Slopes

There are three ways to order a fence section - standard, rackable, and double punched. They accommodate a slope from 3" to 39" over the span of the fence section depending on the style and grade of fence.

Using Different Heights

Certain applications may require you to combine different heights in the same fence line. You would need to order end posts for the taller panel and attach the shorter panel to the same post with wall brackets.